A pinhole leak dripping inside a wall, corroded galvanized pipe finally giving out, or a slab leak that's been driving up the water bill for weeks — pipe failures range from a slow drip to a real flood. Our Billings technicians repair copper, PEX, and galvanized systems alike.
Copper, PEX, CPVC, and galvanized steel repair are all within our Billings technicians' regular scope of work.
We locate the exact leak point with detection equipment before opening any wall or slab.
Trucks stocked with common fittings are staged throughout Billings, MT for same-day repair.
You'll get a written price once the leak is located and the repair scope is clear.
From a single pinhole leak to a full section of corroded galvanized pipe, our technicians match the repair to the actual damage.
We check nearby sections of pipe too, since one pinhole leak sometimes signals broader corrosion.
Copper repair work is done to match existing pipe sizing and pressure requirements.
PEX repiping is often faster and less invasive than replacing pipe in-kind.
Corroding galvanized pipe restricting water pressure gets replaced section by section or as a full re-pipe, depending on extent.
We keep the opening targeted and small by pinpointing the leak location first.
We repair the immediate break and can advise on insulation or heat tape for vulnerable lines.
Active visible leaks get priority dispatch across Billings.
Trucks stocked for Billings, MT's common pipe materials mean fewer follow-up visits for parts.
The leak is located precisely, the repair scope explained, and a flat price quoted before any cutting begins.
We test the repair under normal water pressure before calling the job done, then back it in writing.
"Pinhole leak behind the washer — found it and repaired it same day without opening the whole wall." — Homeowner, Billings
"Frozen pipe burst over a cold weekend, they repaired it and suggested insulation to prevent a repeat." — Billings resident
"Soldered joint repair was clean work, no leaks since, and reasonably priced." — Billings customer
Our pipe repair technicians cover Billings and the surrounding Billings, MT area, with detection equipment on every truck.
We locate the leak first, which keeps the repair opening small and targeted.
We'll assess the extent and give you honest numbers on spot repair versus full replacement.
PEX resists corrosion and scale better and is often faster to install; copper is more traditional and very durable when properly maintained.
Cost depends on leak location and accessibility; we'll quote a flat price once the leak is located.
We repair the damaged section and check nearby pipe for additional stress from the freeze.
We aim to minimize the opening required, though every slab leak is assessed individually.
Fast dispatch across Billings, MT for active leaks.
Call +1-855-718-1500